Adjusting R8 to Increase HP-97 Printer Intensity
|
02-17-2021, 04:33 AM
(This post was last modified: 02-17-2021 05:25 AM by James Linder.)
Post: #7
|
|||
|
|||
RE: Adjusting R8 to Increase HP-97 Printer Intensity
I ordered the PCB mount potentiometers. I see they have 3 connectors.
I see 1st or left terminal is to be grounded, middle #2 is input and right # 3 is output to PCB. In the pictures showing R8 which end is the output from R8 that is Input to #2 of the potentiometer? Also, where would the most convenient ground be located for terminal #1 of the potentiometer?I’m just a beginner on circuits and want to make certain that I do not screw up the installation. Do you think increasing resistance is guaranteed to increase print intensity? I bought some 50k ohm potentiometers in addition to the 20K’s just in case I need to add more resistance than 20K to achieve the desired results. Thank you very much for your help!! |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)