HP Forums / HP Calculators (and very old HP Computers) / General Forum v / NutStudio tools 3.1.1 available

Post Reply 
NutStudio tools 3.1.1 available
06-23-2020, 01:05 AM (This post was last modified: 06-23-2020 07:45 PM by Sylvain Cote.)
Post: #6
Sylvain Cote Offline
Senior Member
 		Posts: 2,097
Joined: Dec 2013
RE: NutStudio tools 3.1.1 available
(06-22-2020 11:20 PM)smartin Wrote:  Installation failed on macOS 10.14.6. What is the recommended version of macOS?
Hello Steve,
My setup is: macOS 10.15.5 on a MacBookPro 15" 2019.
For security reason, I had to open up System Preferences, Security & Privacy then authorize the installation program to run, after that the installation went flawlessly.
This is a command line application, so you have to start a shell then type: asnut -v to get the message NutStudio assembler for Nut version 3.1.1.
Sylvain
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
NutStudio tools 3.1.1 available - hth - 06-04-2020, 04:36 AM
RE: NutStudio tools 3.1.1 available - hth - 06-04-2020, 03:19 PM
RE: NutStudio tools 3.1.1 available - Sylvain Cote - 06-23-2020 01:05 AM
RE: NutStudio tools 3.1.1 available - hth - 06-23-2020, 09:16 PM
RE: NutStudio tools 3.1.1 available - hth - 06-25-2020, 02:14 AM
RE: NutStudio tools 3.1.1 available - hth - 06-30-2020, 05:39 AM
RE: NutStudio tools 3.1.1 available - HP67 - 07-09-2020, 06:46 PM
RE: NutStudio tools 3.1.1 available - hth - 07-09-2020, 08:20 PM
RE: NutStudio tools 3.1.1 available - HP67 - 07-14-2020, 02:35 PM
RE: NutStudio tools 3.1.1 available - hth - 07-29-2020, 09:16 PM
RE: NutStudio tools 3.1.1 available - hth - 07-31-2020, 05:01 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication