newRPL - Updated to build 1510 [official build remains at 1487]

[Claudio L.]

(06-15-2022 07:32 PM)spiff72 Wrote:  One more question regarding fonts on the Prime...

The default font is quite large - OK for the stack, but too big for the menus. I have successfully set the menus to Font10A (which is much smaller than the default font size), but setting the stack to this font makes it too small to be usable. Once the default fonts are changed, is there no way to get back to the default font without a reset? The documentation shows Font10A as the largest - but there must be a larger one internally stored that is bigger and used as the default. Does that font have a name that can be used with the ->FNT commands?

Lots of questions:

On the keyboard: Esc-Hold replaced On-hold (so it's not only to turn it off, all the shortcuts to change precision, number formatting, etc. that use On-hold on the 50g will work with Esc-hold on the Prime).
On the Fonts issue: Prime includes 2 additional fonts, 'Font18' and 'Font24', which are the defaults for the menus and the stack respectively. You are completely right, the ideal font for the menus seems to be an intermediate between 'Font10A' and 'Font18', most likely a 14 pixels high font which hasn't been created so far.