newRPL - Updated to build 1510 [official build remains at 1487]

[gianluca]

(09-01-2021 04:53 PM)Claudio L. Wrote:  Using the paperclip hole for reset makes it very hard to be quick enough (because you are holding the calc in the air), so I lay the calc flat and do a software Reset (On+A+F then Shift+Reset or in this case from the Data Abort screen) followed by a triple-click very fast.
If you do it quick enough (might have to try a couple of times), it will show "EXCEPTION: Wipeout requested". Now you'll select "Clear Memory" pressing ALL 3 SHIFTS simultaneously (ON+RS+LS+(C or D)).

Takes a long time to explain it, but a fraction of a second to do it, that's life

Alright, I should definitely try and learn these manual skills.

(09-01-2021 04:58 PM)Claudio L. Wrote:  By the way, this happened to me also in some occasions but only between 1487 and 1497. I tried older versions and did not have a problem upgrading. I do not know why, so I added a note on the first post to make sure you back up before (did you!?? I hope so).

Yes, I did :-) .

Thank you again.

GianLuca