USB power module and 41CL update
|
03-25-2019, 12:05 AM
(This post was last modified: 03-25-2019 02:56 AM by Diego Diaz.)
Post: #13
|
|||
|
|||
RE: USB power module and 41CL update
Hi Meindert,
Hope you're doing well. Regarding the 3D printed module housings, I haven't had the chance to check one of those, but as long as they have the same internal dimensions and tabs to firmly retain the connector in place, it should be ok. I assume that the connectors you have are remaining from your MLDL2K project. Do they still have the securing tabs? (These tabs have to be removed to install the connector in the Card Reader housing. As you know for sure :-) Look forward to reading from you. Best wishes. Diego. "Do not suppose, check it twice." |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)