HP25C repair, help needed
|
01-27-2019, 07:28 AM
Post: #33
|
|||
|
|||
RE: HP25C repair, help needed
(01-26-2019 10:23 AM)albertofenini Wrote: Thank you very much for the excellent idea ! I used this tape from Adafruit. The adhesive is claimed to be conductive, but it wasn't conductive enough to satisfy my continuity tester, so what I ended up doing was to cut the tape into squares with a tab (see crude diagram below), then remove the backing to expose the adhesive, fold the tab under the square, then press the square onto the PCB, so the copper surface of the tab makes direct contact with the pad on the board. Hope that made sense. Good luck! Code: +-----+ |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)