New G2 HP Prime
|
10-29-2018, 03:48 AM
(This post was last modified: 10-29-2018 03:49 AM by Joe Horn.)
Post: #179
|
|||
|
|||
RE: New G2 HP Prime
(10-28-2018 10:52 PM)akmon Wrote: I've a question about coma mode. I've been a few days without using the Calc. After pressing On. It did not start. Then I pushed several times and now It restart. If pressing On turns on your G2 immediately, then it was NOT in coma mode. Contrary to what has been said by everybody else, pressing Shift+On is NOT sufficient to start coma mode. You have to press Shift+On and KEEP HOLDING THEM DOWN briefly (about half a second). The smaller-than-normal "hp" logo blinks very briefly when coma mode is ready to begin, but it's such a brief blink that you'll only see it if you watch for it very carefully. If you release Shift+On too soon (before that blink) then a normal power-down occurs (not coma mode), and pressing On turns on the G2 immediately. However, once G2 really is in coma mode, pressing On takes a couple seconds to turn on your calculator. Several presses are not needed; just press On once and then wait. After a few seconds, the screen turns on. That's proof that Prime was in coma mode. Disclaimer: I'm pretty sure the above is right, but if it's not, please correct me. <0|ɸ|0> -Joe- |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)