New G2 HP Prime

[toml_12953]

(08-30-2018 06:21 PM)Anders Wrote:  

(08-30-2018 05:45 PM)Albert Chan Wrote:  Are you sure the numbers are right ? Seems off by a decimal point ...

Might be better to revert back to global variables, and check the real overhead.

No i made a typo, it should be 0.158_s (hehe)..
but I payed around and made the important variables global:

I now get 0.707_s +/- 0.1 for this program. A bit less than before. and I was wrong the first test with out the FOR 1 to 10 loop I did, should of course be 0.158 s. Sorry for the confusion I caused

If you want to run the program without having to modify it by adding the timing code, you can use TEVAL from the home screen. It's usually best to compare unmodified code. Then you don't have to worry about unintended side effects changing the timing.