MANPIP

[Thomas Klemm]

(04-09-2014 09:50 PM)Jerussi Wrote:  BTW, I did fix the FS?C 22 to the correct input method per your info. I checked it line by line too. I am still getting the "DATA ERROR" but now it is stopping at line 52 /

Code:

51   RCL 00      ; n
52   /

That means that n is 0. You can just as well use the following to set that value:
0.013
STO 00

Quote:Also, the program is not prompting me for the input at the begining. I do not understand this as I see all the "PROMPT"s in the program listing???

You say that PROMPT doesn't work properly?

From the manual:

Quote:The PROMPT instruction in a program displays the contents of the ALPHA register and stops program execution.

Thanks for the attachments. It will take a while to read them. Thus you have to be a little patient with me. It turned out the problem is a little more difficult than I assumed at first sight.

Cheers
Thomas