Post Reply 
WP-34S Rectangular/Polar (Suggested Change)
04-07-2014, 01:34 AM
Post: #12
RE: WP-34S Rectangular/Polar (Suggested Change)
Look at my original posting. The only change I was suggesting was to change the


function call to


at the end of the "Polar to Rectangular" and "Rectangular to Polar routines".

I apologize if I made it sound more grandiose that that small change.

The only case I can think of where incompatibilities with older programs might occur is if a program
COUNTED on the value in the I register not being altered by the R->P or P->R routines.
I think one would be hard pressed to find such a program.
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: WP-34S Rectangular/Polar (Suggested Change) - BarryMead - 04-07-2014 01:34 AM

User(s) browsing this thread: 1 Guest(s)