Programming issue HP41CX

[jhaig99]

(03-14-2018 06:19 PM)Dieter Wrote:  

(03-12-2018 05:51 PM)jhaig99 Wrote:  I am using the i41CX+ on my iPad. Is there a way to add/build/make a keyboard overlay for use with my V13 program? Is there a way to replace the GOLD characters with my program characters?

James, I have attached two PNG files that may be used with i41CX+. These are two overlays with labels for the three top key rows. Probably the labelling is wrong as I was not able to decipher the words and symbols of the original overlay which is included in the PDF you posted some time ago. This also is the result of a quick-and-dirty job without much care about exact alignment an other details. But it's only a test to find out which file format(s) will work:

One of the files uses an alpha channel for transparency, which is the same as the blank overlay file that can be downloaded from the mentioned source. A closer look shows that the transparent sections of the blank overlay includes parts from another one – which is not visible, but not a clean solution. The other PNG file uses a different method, it's a 4-bit PNG where one entry in the color palette has been set to transparent. Maybe you – or someone else – may check if they both work on i41CX+.

Dieter

I downloaded these files to my dropbox and was able to import into Port 1 and have them show up in the list on my i41CX+, but when I went to load/assign to my i41CX+ it said Module Load Error. I am investigating the module manual loading requirements. All my modules in my i41CX+ say No Module. Any ideas?