Programming issue HP41CX

[jhaig99]

(02-15-2018 07:51 AM)J-F Garnier Wrote:  Well, I typed the program in my Emu41 (it didn't take me too much time).
After packing (GTO ..), the program size is 1997 bytes and there are still 8 free registers with SIZE=26.

There may be errors in my typing, I'm not sure of some 0 and 8 characters in the scanned document. It should not change the program size so much if a few STO/RCL 10 and STO/RCL 18 are incorrect.

So James, the question is still there: why can't you key this program in your 41C?

Attached is the listing generated with Emu41. Note that the append character (used once at step 45) is represented with the character `.

While I was entering the program, I noticed these strange steps:
step 453: X<0? LOG
step 145: 1 /
step 225: 1 *
step 252: 1 *
step 371: 1 *
??

J-F

I down loaded i41CX+ to my iPad and entered the program (correcting original entry errors) and it fit fine, but does not run as I remember.

Question: The program has a keyboard overlay. Do I need to label the keys to match the overlay or is that part in the program? When I enter the primary data to solve for Cv for example, when I enter the SG value, say 0.6, the program should return SG=0.6. It does not.