Programming issue HP41CX

[jhaig99]

(02-05-2018 11:10 PM)rprosperi Wrote:  

(02-05-2018 08:42 PM)jhaig99 Wrote:  I am somewhat of a novice user trying to manually load a 859 step program into my 41CX calculator since the mag cards I have no longer work. When I get to step 792 I run out of memory. The program calls for size 026. The program loaded fine on mag cards when they worked.

Any ideas as to why the mag card program loaded and the manual entry of the program steps will not?

Are there any other programs loaded? Use CAT-1 to check. Remove any programs you don't need by XEQ CLP then provide the program name (as listed in CAT-1). Be sure you don't remove the current program by mistake, it would be a PITA to have to enter all those steps again.

Are you sure you have size 26 set and no higher? XEQ "SIZE?" to check.

An empty CS should be able to fit it, so there must be other programs or registers in use. Also, try XEQ "PACK" to compact RAM.

Verified no other programs or keys assigned. Size 026 is set. I'm going to work Dieter's solution this afternoon.