Post Reply 
newRPL - build 1255 released! [updated to 1299]
01-02-2018, 06:36 AM (This post was last modified: 01-02-2018 07:28 AM by BarryMead.)
Post: #59
RE: newRPL - build 1001 released!
Claudio: I was curious how/where you installed your qt-project.org download file.
My guess is that in your case you installed it as root user and selected the nonstandard
install locations of /usr/local/Qt/ rather than /opt/Qt/... which is the default location if installed in root mode. I installed my copy in non-root (user) mode so it put the files under $HOME/Qt/...

From the directions you mentioned regarding the GDB debugger location it did not match my system. There was no executable gdb file installed by the qt-project run file. The only executable gdb on my system is /usr/bin/gdb

The installer installed NOTHING in /usr/local/bin . I only mention this because GDB instructions on the wiki still confuse me. Thanks again for all of your patience and help. You were right I was looking for any excuse to NOT GIVE UP. I want to apologize to the forum members if I sounded too negative. After scratching my head for 40+ hours I was a bit frustrated and didn't know where else to turn for help/answers. Thanks for bearing with me through that!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: newRPL - build 1001 released! - pier4r - 12-16-2017, 08:03 AM
newRPL - on Hp 39gs - Martin Hepperle - 06-05-2019, 06:51 AM
RE: newRPL - build 1001 released! - pier4r - 12-23-2017, 10:16 AM
RE: newRPL - build 1001 released! - pier4r - 01-01-2018, 09:42 AM
t - Claudio L. - 01-01-2018, 03:06 PM
RE: newRPL - build 1001 released! - pier4r - 01-01-2018, 03:41 PM
RE: newRPL - build 1001 released! - BarryMead - 01-02-2018 06:36 AM
RE: newRPL - build 1001 released! - pier4r - 01-02-2018, 04:54 PM
RE: newRPL - build 1001 released! - pier4r - 01-02-2018, 06:58 PM
newRPL - brickviking - 10-05-2018, 06:01 AM
How to participate? - erazor - 12-13-2019, 07:12 AM



User(s) browsing this thread: 2 Guest(s)