Post Reply 
HP 38E
03-10-2014, 07:54 AM
Post: #2
RE: HP 38E
Hi Jorge,

you may check the physical condition of the contacts of the begin/end-switch on the PCB. Because it's a mechanical switch, there may be some abrasion and/or some dirt prohibiting the correct contact.

Best regards

Karl
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP 38E - Jorge Tucakov - 03-06-2014, 04:34 PM
RE: HP 38E - Karl-Ludwig Butte - 03-10-2014 07:54 AM



User(s) browsing this thread: 1 Guest(s)