Threaded Mode | Linear Mode

Dave Frederickson · (This post was last modified: 03-26-2017 03:27 AM by Dave Frederickson.)

(03-26-2017 01:06 AM)rprosperi Wrote:
(03-26-2017 12:40 AM)Adalin Wrote: I still need to get my HP9122S to work

MASSMEM IS :2 does not work, neither does INITIALIZE DISK:MASSMEM

The 9122S drive uses the SS/80 command protocol, which is not supported by the '71 HP-IL, and likely no other HP-IL controllers, including the HP-110 and HP-110+, which use the Amigo (and Filbert) protocols. The 9121 drive uses Amigo, so it's possible that could work if you have one.

From the 9114A CE Handbook:
The HP 9114A Drive supports both the SUBSET/80 and the FILBERT
command set. FILBERT is the command set used by the 82161A
Cassette Tape Drive.

The 110, 110+, and 9114 all support SS/80.
https://groups.io/g/hpseries80/wiki/HP-8...ory-layout

Code:

Controller                         Amigo      Filbert    SS/80, CS/80

-------------------------------------------------------------------

HP 110, 110+                       -          Filbert    SS/80

HP 110, 110+, AMIGO.SYS            Amigo      Filbert    SS/80

HP-41, HP-IL module                -          Filbert    -

HP-71B, HP-IL module               -          Filbert    -

HP-75C/D                           -          Filbert    -

Series-80, HP-IB I/F, MS-ROM       Amigo      -          -

Series-80, HP-IB I/F, MS+EMS-ROM   Amigo      -          SS/80 

Series-80, HP-IL I/F               -          -          - 

HP Integral PC, HP-IB I/F          -          -          SS/80

Peripheral                         Amigo      Filbert    SS/80, CS/80

-------------------------------------------------------------------

9114A/B                            -          Filbert    SS/80

82161A Cassette Drive              -          Filbert    -

most HP-IB Drives (e.g. 9133D)     -          -          SS/80

some HP-IB Drives (e.g. 9133XV)    Amigo      -          -

ILPer/pyILPER Emulators            -          Filbert    -