Post Reply 
A replacement for the HP-41 zebra connector
04-20-2017, 01:56 AM
Post: #42
RE: A replacement for the HP-41 zebra connector
Hi Mark,

I don't have a very good means of measuring the spacing between the pads. From the below pic it looks like about 25 mils. Contact width also looks like 25 mils.

[Image: iwhmj5.jpg]

There are a lot more 41's out there than 71's and of that this flex would be only for the later version. Of that, how many folks are doing repairs caused by leaking batteries? Not very many.

What's the minimum? Is there any savings in eliminating the coverlay, the polyimide protective layer, or because of the minimum charge is that a moot point?

Dave
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: A replacement for the HP-41 zebra connector - Dave Frederickson - 04-20-2017 01:56 AM



User(s) browsing this thread: 1 Guest(s)