Search
Member List
Calendar
Help
|
fighting with a HP41c
|
|
01-03-2017, 10:02 PM
Post: #5
|
|||
|
|||
|
RE: fighting with a HP41c
One more addition to Raymond's suggestions:
I have had one of the contact/prongs disconnect at the solder joint but look fine. Depending on how you were holding the probes to them, you might have been improving the contact. Gently using a pin, you could pull or push one side away to see if they separate. Good luck on your beautiful Tall Key unit. |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
fighting with a HP41c - aurelio - 01-01-2017, 06:46 PM
RE: fighting with a HP41c - Raymond Del Tondo - 01-02-2017, 06:24 PM
RE: fighting with a HP41c - Brad Barton - 01-03-2017, 02:01 PM
RE: fighting with a HP41c - aurelio - 01-03-2017, 08:23 PM
RE: fighting with a HP41c - d b - 01-03-2017 10:02 PM
RE: fighting with a HP41c - aurelio - 01-03-2017, 10:46 PM
RE: fighting with a HP41c - aurelio - 01-04-2017, 10:26 PM
RE: fighting with a HP41c - AndiGer - 01-04-2017, 05:51 PM
RE: fighting with a HP41c - aurelio - 01-04-2017, 10:23 PM
RE: fighting with a HP41c - AndiGer - 01-05-2017, 08:26 PM
|
User(s) browsing this thread: 1 Guest(s)