HP97 printer gear replacement
|
12-15-2021, 03:54 PM
Post: #11
|
|||
|
|||
RE: HP97 printer gear replacement
Hi Mark,
I recently 3D-printed a few of these gears and they seem to work ok. (the top ones are what was left of the original gears :-) ) Regards, Bas (12-09-2021 06:31 PM)pipesm Wrote: I just got an HP-97. The middle gear in the printer is broken. It doesn’t seem to be rubber, it is some beige plastic. It sits between the motor and printhead gear. Is this part the one mentioned above, or, do I need a different one? 35 | 45 | 55 | 65 | 10 | 19C | 21 | 25 | 29C | 34E Ir | 41C | 33E | 33C | 34C | 67 | 41CV | 41CX | 71B | 75B | 10C | 11C | 12C | 15C | 16C | 41CL | DM41X | DM16L |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)