[HP-35s] direct stack designation
|
09-05-2016, 02:59 PM
(This post was last modified: 09-05-2016 03:25 PM by wojtek.)
Post: #2
|
|||
|
|||
RE: [HP-35s] direct stack designation
(09-05-2016 02:20 PM)Eamoex Wrote: So here's my question: is it right that, on the HP-35s there is no equivalent to the stack manipulation syntax "STO . Z", or "RCL . T" found in the HP-41?The answer is unfortunately YES. Compared to 41c, 35s is just a toy for dummies although some users like it and write even quite complicated programs for it. My advice: buy 50g, you will have full set of stack manipulation commands and muuuch more |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[HP-35s] direct stack designation - Eamoex - 09-05-2016, 02:20 PM
RE: [HP-35s] direct stack designation - wojtek - 09-05-2016 02:59 PM
RE: [HP-35s] direct stack designation - Didier Lachieze - 09-05-2016, 03:31 PM
RE: [HP-35s] direct stack designation - Eamoex - 09-05-2016, 08:17 PM
RE: [HP-35s] direct stack designation - Dieter - 09-05-2016, 08:56 PM
RE: [HP-35s] direct stack designation - Eamoex - 09-05-2016, 09:27 PM
RE: [HP-35s] direct stack designation - Massimo Gnerucci - 09-05-2016, 09:41 PM
RE: [HP-35s] direct stack designation - Eamoex - 09-05-2016, 03:36 PM
RE: [HP-35s] direct stack designation - Massimo Gnerucci - 09-05-2016, 05:02 PM
|
User(s) browsing this thread: 1 Guest(s)