Looking for (idler?) gear wheel of HP-46 printer unit

[Sadsilence]

(06-20-2016 10:55 AM)Duane Hess Wrote:  Will share what I found about this gear. If you can actually buy one, let me know!

Of course I will. Maybe it would be a good chance to dig into 3D printer subject, but most probably much to difficult as starting point.

(06-20-2016 10:55 AM)Duane Hess Wrote:  The 46 printer is the same lineage as other drum/impact printers. I purchased parts to fabricate the gear myself. Last of the parts arrived last week. Haven't assembled it yet.

Basically its a small gear, large gear and a brass bushing. I intend on epoxy-ing them together to fabricate the gear.

Will post where I purchased the stuff from & the part numbers. Don't have it convenient at the moment.

Likely will be 1-2 days before providing the info.

Thank you very much and a brilliant idea. I have not even come close to the idea, building it from two seperate gear wheels.