Post Reply 
HP41C - workaround for the SIZE? missing
04-19-2016, 04:11 PM (This post was last modified: 04-19-2016 04:13 PM by wojtek.)
Post: #4
RE: HP41C - workaround for the SIZE? missing
(04-19-2016 03:42 PM)RMollov Wrote:  
(04-19-2016 02:49 PM)wojtek Wrote:  How would you determine the number of data registers set in the past (and forgotten) in the HP41C?
There is no SIZE? command in this calculator.
Very simple. Start RCL-ing from maximum possible register number down. Depending on how much memory is available will take you less than a minute to figure it out. Wink

:-) :-) good joke, thank you, I know that way of course.
Less than a minute? Even if you have quad memory installed?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: HP41C - workaround for the SIZE? missing - wojtek - 04-19-2016 04:11 PM



User(s) browsing this thread: 1 Guest(s)