41CL Flash updating
|
01-04-2016, 06:05 PM
Post: #2
|
|||
|
|||
RE: 41CL Flash updating
(01-04-2016 05:51 PM)Geir Isene Wrote: I had a scare while updating flash on my CL this weekend. I accidentally bumped the connection cord so that it popped out slightly from the 41. This apparently made a mish-mash of some of the RAM pages (my HEPAX RAM at 808 and 809 to be specific), effectively locking up the calc. I had to remove the batteries until MEMORY LOST. But then I managed to replug said HEPAX RAM and it locked up again. Next time, I did YMCPY from flash to ensure pages 808 and 809 were "sane". Then everything was fine. This sounds like the result of a power glitch. Probably because the serial connector wire torqued the battery block. I have though about gluing the port cover with the serial port to the calc body, because I do the same thing fairly regularly. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
41CL Flash updating - Monte Dalrymple - 01-04-2016, 04:16 AM
|
User(s) browsing this thread: 1 Guest(s)