Plastic (or Aluminum as you want) case for NP-25

[Waon Shinyoe]

Hi all,

I've received the free NP-25 from Chris Chung weeks before. Many thanks to Chris!
Then I found it was a little bit awkward to use NP 25 since it's only a PCB. So I decided to make a case for it. And this is the result! The case was machined by CNC with sloping surface on the edge and thus fits quite well in hand. The assembly is also simple: Just push the NP-25 PCB into the case. I make it tight @25℃, which means under most condition it's tight enough.

   

   

And now I'd like to sell this simple but useful accessory to the NP-25 users. Here are the prices:

Plastic case: $12
Aluminum case with surface treatment (anodized, black color): $20

Shipping cost: Don't know now. But since NP 25 can be shipped at such a low price ($8 world wide), I believe I could figure out a cheap shipping way...