HP 35s Discontinued or Marketing trick?
|
04-04-2016, 04:05 PM
(This post was last modified: 04-04-2016 04:07 PM by wojtek.)
Post: #30
|
|||
|
|||
RE: HP 35s Discontinued or Marketing trick?
(04-04-2016 12:55 PM)Han Wrote: Every photo I have seen of the HP 35S makes me think that the case is slightly bowed -- looks slightly wider in the middle and thinner toward the top/bottom. Is this in fact how it was designed, or just how it is photographed? And if by design, why? It seems like a straight edge would be lest costly than a bowed edge.Perhaps not. If the overall cost consists of three main parts: 1 - preparing a mould 2 - plastic 3 - pressing then 1 would be a little bit bigger with bowed edge, 3 would be the same but 2 (cost of plastic) would be lesser. So perhaps the bowed edges enabled them to make cheaper body. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)