Post Reply 
Is the 12C SDK still available?
11-22-2015, 06:10 PM
Post: #21
RE: Is the 12C SDK still available?
(11-22-2015 05:47 PM)rprosperi Wrote:  1. If the case (and presumably the 6-pin connector) are the same, is there any danger of harming the new units if I use the older (serial) cable? Or I suppose the opposite as well (though less likely with lower voltages?)

I don't think that harm will come to the calculator either way. I've made both mistakes in my testing and nothing bad happened. I'm bothered by the fact that HP used the same -- impossible to buy -- connector, they had the chance to install a micro USB connector. My guess is that HP wanted to do this as a silent roll-out so kept the case exactly the same. They also don't want to encourage hacking of the 12C, I think.

Quote:2. Can you post a pic of the new back-plate design (unless it's pre-production, then it's kinda meaningless)?

Yeah, it might be misleading. I need to look at it the next time I'm in Staples to see what the latest production run looks like (if they have it on display).

-katie

Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Is the 12C SDK still available? - emece67 - 11-20-2015, 09:59 PM
RE: Is the 12C SDK still available? - Katie Wasserman - 11-22-2015 06:10 PM
RE: Is the 12C SDK still available? - d b - 11-25-2015, 11:52 PM
RE: Is the 12C SDK still available? - Dol - 09-06-2016, 07:11 PM
RE: Is the 12C SDK still available? - dls - 03-06-2022, 12:57 PM



User(s) browsing this thread: 2 Guest(s)