Post Reply 
Is the 12C SDK still available?
11-22-2015, 05:47 PM
Post: #20
RE: Is the 12C SDK still available?
(11-22-2015 04:52 PM)Katie Wasserman Wrote:  ...the physical case is indistinguishable from the prior Atmel version.

- In my sample, the back plate is printed slightly differently on the latest version. But I don't know if this is significant as this might change often between batch runs.

Katie:

Thanks for all these great details!

A few questions:

1. If the case (and presumably the 6-pin connector) are the same, is there any danger of harming the new units if I use the older (serial) cable? Or I suppose the opposite as well (though less likely with lower voltages?)

2. Can you post a pic of the new back-plate design (unless it's pre-production, then it's kinda meaningless)?

Thanks.

--Bob Prosperi
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Is the 12C SDK still available? - emece67 - 11-20-2015, 09:59 PM
RE: Is the 12C SDK still available? - rprosperi - 11-22-2015 05:47 PM
RE: Is the 12C SDK still available? - d b - 11-25-2015, 11:52 PM
RE: Is the 12C SDK still available? - Dol - 09-06-2016, 07:11 PM
RE: Is the 12C SDK still available? - dls - 03-06-2022, 12:57 PM



User(s) browsing this thread: 2 Guest(s)