Post Reply 
New to programming
06-10-2015, 06:32 AM
Post: #3
RE: New to programming
(06-10-2015 01:24 AM)Clod Wrote:  Howeeeeeeeeeeeeeeeeeeever, it seems I'm not able to use the "EXPORT XXX()" command which would allow me not to write "tvf()" manually (which is a pain in the ass).

The CAS programs are not visible as other programs in the Toolbox > User menu but they are listed in the Vars > CAS menu, so you can access them without having to spell them on the keyboard.

On this topic, there is a great article from Han in the Article Forum section: HP Prime CAS Programming.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
New to programming - Clod - 06-10-2015, 01:24 AM
RE: New to programming - Clod - 06-10-2015, 04:56 AM
RE: New to programming - Didier Lachieze - 06-10-2015 06:32 AM
RE: New to programming - Angus - 06-10-2015, 06:33 AM
RE: New to programming - Clod - 06-11-2015, 02:19 AM
RE: New to programming - Han - 06-11-2015, 03:07 AM
RE: New to programming - Clod - 06-11-2015, 04:20 AM



User(s) browsing this thread: 1 Guest(s)