WP34s flashing procedure
|
02-27-2015, 03:49 AM
Post: #12
|
|||
|
|||
RE: WP34s flashing procedure
(02-26-2015 10:53 PM)matthiaspaul Wrote:I believe that the "Erase" button shorts the "Erase" pin to "VCC" not "GND". At least that is what the instructions say in the manual.(02-26-2015 10:35 PM)Dieter Wrote: how?Select "diode check" or "resistance measurement" and connect the multimeter to the programming cable's ERASE and GND pins. The multimeter should display "open connection" or "infinity". If you then press and hold the ERASE button, the multimeter should indicate a short circuit (close to 0 ohm). |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)