WP34s flashing procedure
|
02-26-2015, 11:05 PM
Post: #6
|
|||
|
|||
RE: WP34s flashing procedure
(02-26-2015 10:53 PM)matthiaspaul Wrote: Select "diode check" or "resistance measurement" and connect the multimeter to the programming cable's ERASE and GND pins. I know how to handle a multimeter, but how should I know which of the six pins on the cable is the ERASE resp. GND pin? So which of the contacts should get connected if the ERASE button is pressed? Dieter |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)