Post Reply 
HP 32SII success and woes
02-24-2015, 02:56 AM
Post: #48
RE: HP 32SII success and woes
(02-24-2015 02:44 AM)Katie Wasserman Wrote:  Pretty much any silicon diode will do just fine, since they all have about a 0.6v forward voltage drop and any one will easily handle the few mA of current. A 1N4148 is a good choice. I doubt that the capacitor is causing the problem you have.

Thank you for the confirmation. I do not think I will get another chance at taking this apart without damaging the twisty clips, so I may elect to replace the capacitor as a preventive measure.

-- Sanjeev Visvanatha
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: HP 32SII success and woes - renif - 02-10-2015, 01:56 PM
RE: HP 32SII success and woes - rprosperi - 02-11-2015, 02:12 PM
RE: HP 32SII success and woes - rprosperi - 02-11-2015, 10:55 PM
RE: HP 32SII success and woes - rprosperi - 02-12-2015, 12:21 AM
RE: HP 32SII success and woes - rprosperi - 02-13-2015, 12:51 PM
RE: HP 32SII success and woes - rprosperi - 02-13-2015, 06:53 PM
RE: HP 32SII success and woes - rprosperi - 02-14-2015, 02:03 PM
RE: HP 32SII success and woes - jebem - 02-16-2015, 09:36 AM
RE: HP 32SII success and woes - jebem - 02-16-2015, 03:22 PM
RE: HP 32SII success and woes - jebem - 02-17-2015, 03:05 PM
RE: HP 32SII success and woes - jebem - 02-20-2015, 03:39 PM
RE: HP 32SII success and woes - Sanjeev Visvanatha - 02-24-2015 02:56 AM
RE: HP 32SII success and woes - rprosperi - 02-28-2015, 04:32 AM



User(s) browsing this thread: 2 Guest(s)