HP 82160A HP-il Interface looptest
|
11-27-2014, 01:51 AM
Post: #2
|
|||
|
|||
RE: HP 82160A HP-il Interface looptest
(11-26-2014 05:02 PM)workspace Wrote: Is there a short program example or even a built in "loop test". The command PWRUP or PWRDN should give you your loopback test. If the two wire are connected together, one of the above commands will not give you any feedback. If the two wire are disconnected or broken then the "TRANSMIT ERR" message will be displayed on the LCD. Best regards, Sylvain |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP 82160A HP-il Interface looptest - workspace - 11-26-2014, 05:02 PM
RE: HP 82160A HP-il Interface looptest - Sylvain Cote - 11-27-2014 01:51 AM
RE: HP 82160A HP-il Interface looptest - workspace - 11-27-2014, 07:56 AM
RE: HP 82160A HP-il Interface looptest - Marcus von Cube - 11-29-2014, 03:55 PM
RE: HP 82160A HP-il Interface looptest - rprosperi - 11-29-2014, 11:47 PM
RE: HP 82160A HP-il Interface looptest - workspace - 11-30-2014, 11:41 AM
|
User(s) browsing this thread: 1 Guest(s)