Post Reply 
Flashing the WP34s
11-23-2014, 07:28 PM
Post: #4
RE: Flashing the WP34s
(11-23-2014 06:35 PM)Marcus von Cube Wrote:  Repairing the flash is totally possible with the USB board alone. You just need to perform a full erase to the flash with a piece of wire to activate the SAM-BA boot code.
There have been some posts of people who corrupted the flash to the point that the normal samba boot code no-longer works. These people have had to resort to using the JTAG connector to program the flash.
I too had assumed that the poster was confusing the 6-pin serial programming header with the jtag connector but didnt' want to mention it. He could wire his USB board to the 6-pin serial programming header if he wants, but that would just make the wires longer.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Flashing the WP34s - Elite - 11-22-2014, 05:46 PM
RE: Flashing the WP34s - BarryMead - 11-23-2014, 04:50 PM
RE: Flashing the WP34s - Marcus von Cube - 11-23-2014, 06:35 PM
RE: Flashing the WP34s - BarryMead - 11-23-2014 07:28 PM
RE: Flashing the WP34s - Elite - 11-23-2014, 09:09 PM
RE: Flashing the WP34s - Marcus von Cube - 11-23-2014, 11:05 PM
RE: Flashing the WP34s - BarryMead - 11-23-2014, 11:58 PM



User(s) browsing this thread: 1 Guest(s)