ACT available

[Harald]

Integration works fine on the 34E now! Thanks for the update Bernhard!

Does the 34E have extra program memory as well? And if so, how do I access this? The key combinations for the 25E and 29E won't work, as they are already occupied by regular HP34C functions.

Since there is a pdf document containing program codes for the 34e, I would assume it can be programmed by sending a program collection file. But what is the syntax in this case? Do I need a program number as you have shown in your example:

Quote:; Program collection example

; Each program must be preceded by "PROGRAM" followed by a number from 18-99
; the last step must be followed by "END"
; if you use the same program number twice, only the last program will be stored.
; unused program steps will be filled by GTO 00 instructions

; use the following syntax for entering your program steps (not case sensitive)

; "GTO", "FIX", "SCI", "ENG", "STO", "RCL",
; "->HMS", "INT", "SQRT", "Y^X", "SIN", "COS", "TAN", "LN", "LOG", "->R",
; "->H", "FRAC", "x^2", "ABS", "SIN-1", "COS-1", "TAN-1", "e^x", "10^x", "->P",
; "0", "1", "2", "3", "4", "5", "6", "7", "8", "9",
; "x<y", "x>=y", "x!=y", "x=y", "LASTX", "PAUSE", "CLR", "REG", "STK", "/x", "s", "E-"
; "x<0", "x>=0", "x!=0", "x=0", "PI", "NOP", "?", "DEG", "RAD", "GRD", "%", "1/x",
; "-", "+", "*", "/", ".", "R/S", "ENTER", "CHS", "EEX", "CLX", "x<>y", "R", "E+"

; simple counter example, store to Program location 20
PROGRAM 20
1
+
PAUSE
GTO 01
END

And while we are at it, are there any other extra features included in the 34E or is it "just" the 34C functionality that you have implemented?