Post Reply 
HP-41C service module question
10-19-2014, 02:12 PM
Post: #3
RE: HP-41C service module question
I use SM-1C aka ET-11966, the one described in the HP-41C Service Manual. There I also found the reference to ET-11967, see table 4-1. It's required to run the I/O Port test routine, see table 4-2, step 12. As in my opinion this is a very useful test, that's why I'm looking for information about this additional module.

I just checked the HP-41C/CV/CX Service Manual, and interestingly it does not mention this flag-wired module anymore. Instead it references an ET-11945 Port Extender for I/O port testing, see table 4-1 "Recommended Tools" and table 4-2, step 13 (I/O Port Test). Of course it would also be interesting to know more about this "beast".
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: HP-41C service module question - Jurgen Keller - 10-19-2014 02:12 PM
RE: HP-41C service module question - dmh - 09-06-2021, 12:13 PM

User(s) browsing this thread: 1 Guest(s)