Post Reply 
WP34S Reset during printing
09-30-2014, 06:23 PM
Post: #1
WP34S Reset during printing
I have a problem with WP34S 3.3<P>3678 newly expanded with IR transmitter LED.

For the IR transmitter I used a SFH409 transmitter LED and a 365Ohm resistor.

When using the <P>STK printer command everything is ok, but when using a printer command with larger output like <P>REGS the printing stops somewhere around the r10 register with a "Reset" message in display. I thought that maybe caused by low batteries and measured the equipped onces (both >3V) and also using new ones, same problem.

Any hints?

Christoph
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
WP34S Reset during printing - Christoph Giesselink - 09-30-2014 06:23 PM
RE: WP34S Reset during printing - Dieter - 09-30-2014, 08:00 PM
RE: WP34S Reset during printing - Dieter - 09-30-2014, 08:46 PM
RE: WP34S Reset during printing - walter b - 09-30-2014, 09:06 PM
RE: WP34S Reset during printing - walter b - 09-30-2014, 07:56 PM
RE: WP34S Reset during printing - walter b - 09-30-2014, 08:06 PM



User(s) browsing this thread: 1 Guest(s)