Post Reply 
Question about CAS and Graphing
09-25-2014, 08:21 AM
Post: #6
RE: Question about CAS and Graphing
(09-24-2014 10:14 PM)Han Wrote:  In the CAS view, use:

f:=int(x,x);

Now, load the geometry app, and in the [Symb] view enter: plotfunc(f), then hit [Plot]. Not exactly the most natural way, but works because the geometry app is built on the CAS so there is no issue with x vs X.

EDIT: You can also skip using the geometry app if you are happy with a miniature plot. Just type plotfun(f) in the CAS view to get this tiny graph.

Thank you, Han!
Lateral thinking... excellent.
You are very knowledgeable and helpful, as usual!

Concerning your EDIT info on plotfun(f), yes, I tried that a couple of days ago after my previous posting, but I was not sure about if that could be a good answer to the OP, so I preferred to wait for someone with enough expertize on the Prime to add additional useful comments.

Jose Mesquita
RadioMuseum.org member

Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Question about CAS and Graphing - Han - 09-24-2014, 10:14 PM
RE: Question about CAS and Graphing - jebem - 09-25-2014 08:21 AM
RE: Question about CAS and Graphing - Han - 09-25-2014, 01:35 PM
RE: Question about CAS and Graphing - jte - 11-22-2014, 03:01 AM
RE: Question about CAS and Graphing - Han - 11-22-2014, 02:31 PM
RE: Question about CAS and Graphing - jte - 11-23-2014, 06:31 PM
RE: Question about CAS and Graphing - Han - 11-23-2014, 08:42 PM
RE: Question about CAS and Graphing - jte - 11-26-2014, 06:02 AM
RE: Question about CAS and Graphing - Han - 11-22-2014, 02:16 PM
RE: Question about CAS and Graphing - Han - 11-22-2014, 07:26 PM
RE: Question about CAS and Graphing - Han - 11-23-2014, 08:41 PM
RE: Question about CAS and Graphing - Han - 11-24-2014, 11:47 AM
RE: Question about CAS and Graphing - Han - 11-24-2014, 01:29 PM
RE: Question about CAS and Graphing - Han - 11-24-2014, 02:12 PM



User(s) browsing this thread: 1 Guest(s)