Post Reply 
[BUG] Emulator
09-15-2014, 02:04 AM
Post: #1
[BUG] Emulator
Connect the actual HP Prime to your PC and run the emulator. On the emulator, choose Calculator > Connect To > HP Prime to connect the emulator with the HP Prime.

If you are in the Program Catalog, then the "Send" menu button appears, but the emulator screen starts to show screen tearing (perhaps refreshing too much?). Pressing [Esc] without sending anything puts the emulator in the help screen. Unfortunately, the emulator seems unresponsive afterward. To regain control of the emulator, disconnect the emulator from the HP Prime.

If you aren't in the Program Catalog, then this should place the emulator in the app menu (sometimes it does not and you can see the over-refreshing of the screen). Similar problems occur, basically. Regain emulator control as described above.

Graph 3D | QPI | SolveSys
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
[BUG] Emulator - Han - 09-15-2014 02:04 AM

User(s) browsing this thread: 1 Guest(s)