Post Reply 
[V41 + IRBlinky + HP82240B] PRPLOT fails on example
02-25-2022, 05:50 PM (This post was last modified: 02-25-2022 05:51 PM by WrongWay.)
Post: #11
RE: [V41 + IRBlinky + HP82240B] PRPLOT fails on example
(02-25-2022 09:09 AM)Thomas Okken Wrote:  Everything points to 82143A/82162A control codes being sent to an 82240B. Which isn't surprising, because that's what your setup sounds like. But how does the connection between the emulated 41 and the emulated 82240B even work? I'd expect an emulated IR module between the two, not emulated HP-IL. I'm afraid I can offer no advice on how to fix this...

That's a good point. If the control codes being sent aren't for the correct printer then it would stand to reason it should fail. I tried using the V41 Ir-Print.mod module but it immediately sends the cpu into a loop.
I configured the setup as follows the HP-41 uses the HP-IL module, the HP-IL module to connect to the IR Blinky program then that outputs to the printer.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [V41 + IRBlinky + HP82240B] PRPLOT fails on example - WrongWay - 02-25-2022 05:50 PM



User(s) browsing this thread: 1 Guest(s)