41CL reset
|
05-20-2021, 03:18 AM
Post: #9
|
|||
|
|||
RE: 41CL reset
Hi,
This is an exiting fist post on the forum for myself! So the transient power disconnect modified the calculator’s state and also reset the time clone (which is piggy backed on the board so it also lost power). The x-memory, registers, stack are still there. Once I executed MMUEN, I the modules were working again. Thanks. But I dont know why the cat 0 does not show the fancy menu anymore? Finally, can you tell me where the x-memory is stored for it not to be erased , is it in flash? Thanks —Marc-André Beauchamp |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
41CL reset - Ours - 05-19-2021, 03:25 PM
RE: 41CL reset - rprosperi - 05-19-2021, 05:33 PM
RE: 41CL reset - cdmackay - 05-19-2021, 07:53 PM
RE: 41CL reset - twoweims - 05-19-2021, 09:09 PM
RE: 41CL reset - rprosperi - 05-19-2021, 11:04 PM
RE: 41CL reset - cdmackay - 05-20-2021, 05:15 PM
RE: 41CL reset - Sylvain Cote - 05-20-2021, 05:41 PM
RE: 41CL reset - twoweims - 05-19-2021, 11:22 PM
RE: 41CL reset - rprosperi - 05-20-2021, 12:44 AM
RE: 41CL reset - Monte Dalrymple - 05-20-2021, 02:04 AM
RE: 41CL reset - Ours - 05-20-2021 03:18 AM
RE: 41CL reset - Sylvain Cote - 05-20-2021, 12:24 PM
RE: 41CL reset - Ours - 08-01-2023, 06:44 PM
RE: 41CL reset - Sylvain Cote - 08-01-2023, 07:25 PM
RE: 41CL reset - Ours - 08-02-2023, 01:11 AM
RE: 41CL reset - Sylvain Cote - 08-02-2023, 02:03 PM
RE: 41CL reset - Ours - 08-02-2023, 09:55 PM
RE: 41CL reset - Sylvain Cote - 08-03-2023, 12:50 AM
|
User(s) browsing this thread: 1 Guest(s)