Post Reply 
Writing HP41 Programmes on PC & Conversion to .RAW
10-24-2020, 01:18 AM
Post: #7
RE: Writing HP41 Programmes on PC & Conversion to .RAW
Thanks everyone for your prompt suggestions.

Haven't had much time this week to fully sort it out, but I did try running the latest version of the HP41UC utility without success. Doesn't seem to do anything when I double click on the icon so I then tried running in compatibility mode for XP (since notes indicate it was designed to run with Windows XP or later versions). Under compatibility mode, it tries to launch the utility which seems to momentarily flash-up but then disappears. Also tried other compatibility options with similar results. I am running Windows 10 x 64bit.

Didier - how did you get it to run under Windows 10?

Have also downloaded & installed DOSBox but haven't tried to run the utility under DOS yet.

Cheers,

Michael
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Writing HP41 Programmes on PC & Conversion to .RAW - Michael Lopez - 10-24-2020 01:18 AM



User(s) browsing this thread: 1 Guest(s)