Post Reply 
"Wait..." on WP 34S
09-01-2020, 04:12 PM
Post: #1
"Wait..." on WP 34S
I have a WP 34S made from a HP 30b with an IR/USB board. When I use it, most of the time I am getting the "Wait..." message for a non-trivial amount of time for simple operations: putting number on stack, +, - , x, / RCL, swap, etc. My battery voltage was 2.8 which is a bit low so I thought that might be the issue so I connected it to my computer with a USB cable which keeps voltage steady at 3, but I still have the issue. Could I have the calculator in some obscure mode that is causing this?

Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
"Wait..." on WP 34S - brettpim - 09-01-2020 04:12 PM
RE: "Wait..." on WP 34S - ijabbott - 09-01-2020, 06:30 PM
RE: "Wait..." on WP 34S - brettpim - 09-01-2020, 08:16 PM
RE: "Wait..." on WP 34S - ijabbott - 09-02-2020, 03:33 PM
RE: "Wait..." on WP 34S - brettpim - 09-02-2020, 04:21 PM

User(s) browsing this thread: 1 Guest(s)