Post Reply 
[WP-34S] DEG and RAD - diffs
06-05-2014, 06:04 PM (This post was last modified: 06-05-2014 07:20 PM by pito.)
Post: #8
RE: [WP-34S] DEG and RAD - diffs
(06-05-2014 05:45 PM)Marcus von Cube Wrote:  
(06-05-2014 12:08 AM)pito Wrote:  
Code:
RAD mode
180.0/pi * asin(acos(atan(tan(cos(sin(9.0 * pi/180.0))))))

8.999999999999999999999999999999979

You need to do the conversion in each step, not only when you do the first sin() and after the last acos().

I convert 9degree into radians.
Then I do the test (all in radians).
After that I convert back to degree to see the 9.0.
So I do not need to do conversion at each step (mind the calc mode is RAD in this test).

In DEG test the calc mode is DEG and I do not need to do any i/o conversion.
There are conversions done internally at each step (I do assume you do it as the trigo is usually in radians in your libs there).
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[WP-34S] DEG and RAD - diffs - pito - 06-05-2014, 12:08 AM
RE: DEG and RAD - diffs - Paul Dale - 06-05-2014, 12:53 AM
RE: DEG and RAD - diffs - pito - 06-05-2014, 06:27 AM
RE: [WP-34S] DEG and RAD - diffs - pito - 06-05-2014, 01:38 PM
RE: [WP-34S] DEG and RAD - diffs - Dieter - 06-05-2014, 11:12 AM
RE: [WP-34S] DEG and RAD - diffs - pito - 06-05-2014 06:04 PM
RE: [WP-34S] DEG and RAD - diffs - pito - 06-05-2014, 07:57 PM
RE: [WP-34S] DEG and RAD - diffs - pito - 06-05-2014, 10:07 PM
RE: [WP-34S] DEG and RAD - diffs - Dieter - 06-06-2014, 05:27 PM
RE: [WP-34S] DEG and RAD - diffs - pito - 06-07-2014, 12:57 PM



User(s) browsing this thread: 5 Guest(s)