My new(ish) HP-45
|
01-13-2020, 11:00 PM
Post: #6
|
|||
|
|||
RE: My new(ish) HP-45
Thanks for these techniques and tips Tony, very helpful suggestions.
I planned to use a heat gun to soften the label adhesive before pulling it back. I've heard several folks (some that do this all the time) suggest it's best to remove the label fully, clean the old adhesive from the label and the calc. body, and then add new sheet adhesive to mount the label. Either way, I'm not putting the 2 screws underneath back in; I don't know if I'll ever need to open them again (hopefully someone else will be doing it in another 45 years) but there's surely no need to have 6 screws, 4 will do just fine. Thanks. --Bob Prosperi |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)