Spice Low Power

[rprosperi]

Bernhard - This is great news, and will save the life of many Spice calculators. However, may I make a suggestion?

Create a new thread in the General Forum, repeating this new post about the Spice power connector board, and I think you will get much wider (and so, larger) response. There are likely many folks that will not read through 3 pages of Spice Low Power messages that are very much in need of this part, and so would miss your post and question about level of interest.

Also, can you add some short comments about the needed skills and procedure to remove and replace the foil from the main board? Perhaps that is obvious to some people here, but certainly not for others. For example is it strictly a mechanical (of course delicate mechanical) removal and replacement, or is soldering required, etc.

I will also take 5 of these.