HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Programming Pad for RPL Programs

Post Reply 
Programming Pad for RPL Programs
05-21-2014, 05:50 PM (This post was last modified: 05-21-2014 05:50 PM by HP67.)
Post: #13
HP67 Offline
Senior Member
 		Posts: 698
Joined: Dec 2013
RE: Programming Pad for RPL Programs
I think you are right with respect to loop commands that have an implied structure. But if you have a bunch of computations and stack manipulations etc. then the lines get broken up in unhelpful ways. Exactly how that is done I can't tell. I do know my linefeeds are often not respected and lines that I code are broken up in strange ways.
It ain't OVER 'till it's 2 PICK
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Programming Pad for RPL Programs - HP67 - 05-21-2014 05:50 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication