Post Reply 
HP97 Printer Problem
09-13-2019, 07:37 PM
Post: #2
RE: HP97 Printer Problem
There are two common problems that lead to indexing failures, the most common is the tires on the shaft have gone hard and smooth so they don't grip the paper, in my case I replaced the tires with similar sized slices of silicon tubing fixed on with a bit of super glue, be careful not to get any glue in the ratchet at the one end. The other problem is the ridge that runs the length of the shaft fits into a slot in the print head carrier so that it acts like a cam that rotates the outer shaft enough that it jumps ahead a couple teeth on the ratchet as the printhead moves to the left and then advances the paper when it returns to the right. If not assembled correctly no paper advance.

This same shaft is used in the 82162 HPIL thermal printer and also the 82143 printer for the 41.

Paul.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP97 Printer Problem - alejandro3791 - 09-13-2019, 07:04 PM
RE: HP97 Printer Problem - Paul Berger (Canada) - 09-13-2019 07:37 PM
RE: HP97 Printer Problem - alejandro3791 - 09-13-2019, 09:18 PM



User(s) browsing this thread: 1 Guest(s)