(SOLVED) 41CL - DOUBLE HEPAX ACCESS and MMU CONFIG
|
08-21-2019, 05:40 PM
Post: #35
|
|||
|
|||
RE: 41CL - DOUBLE HEPAX ACCESS
Hi, also HP-IL works fine, but I have a problem
in swapping pages: After tested HP-IL with my pyILBOX, I decided to swap on 9CFA that is "my" standard configuration. I typed "9CFA" XEQ PPLUG and my programs are all NOT EXISTENT, so i typed CAT 2 and I discovered: CAT 2 on 9CFA............................CAT 2 on 9CFB TIME 3A....................................EXT FCN 3B CL TIME.....................................CL EXT FCN YFNX 4C....................................TIME 3A SYS FNS...................................CL TIME SER FNS...................................AMC"OS/X MISC FNS.................................OSX BANK2 YFNF 3A...................................YFNX 4C EXT FCN 3B.............................SYS FNS CL EXT FCN.............................SER FNS ................................................MISC FNS ................................................X MASS STG ................................................HEPAX'4H It is evident that the HP-IL configuration on 9CFB is OK, but I don't understand from where arrive this configuration on 9CFA! When I typed CAT 2 on 9CFA, I immediately stopped with R/S and advanced with SST. At last SST the 41CL display 0.0000, but on 9CFB, at last line of CAT 2, continue to display the last line and to exit I have to press <-- (Backspace). Another problem or I typed a mistake? I am sorry ho make this help so long! Now I am very stressed by a problem at an eye, but tomorrow I reinstall your 9CFA configuration, then I repeat the tests. Thank you so much!! |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)