What entry mode do you use the most?
|
04-18-2019, 05:16 PM
(This post was last modified: 04-21-2019 10:22 AM by JMB.)
Post: #4
|
|||
|
|||
RE: What entry mode do you use?
(04-18-2019 01:26 PM)compsystems Wrote: The algebraic word is not very explicit, ...In the HP Pime parlance, "Algebraic" is very explicit. Just read the explanation of the different entry types in the user manual (page 20): ● Textbook—An expression is entered in much the same way as if you were writing it on paper (with some arguments above or below others). In other words, your entry could be two-dimensional. ● Algebraic—An expression is entered on a single line. Your entry is always one-dimensional. ● RPN—Reverse Polish Notation. The arguments of the expression are entered first followed by the operator. The entry of an operator automatically evaluates what has already been entered. Josep Mollera. HP PRIME, HW: C, SW: 2.1.14730 (2023 04 13). |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
What entry mode do you use the most? - Tugdual - 04-18-2019, 12:06 PM
RE: What entry mode do you use? - compsystems - 04-18-2019, 01:26 PM
RE: What entry mode do you use? - JMB - 04-18-2019 05:16 PM
RE: What entry mode do you use the most? - Tugdual - 04-18-2019, 05:38 PM
RE: What entry mode do you use? - Joe Horn - 04-18-2019, 04:58 PM
RE: What entry mode do you use the most? - Tugdual - 04-18-2019, 05:36 PM
|
User(s) browsing this thread: 1 Guest(s)