Faulty PRGM / RUN switch on 29C

[Maximilian Hohmann]

Hello!

(03-22-2019 12:44 PM)rprosperi Wrote:  How will you re-attach the PCB where you removed the heat stakes?

That's the difficult bit! Someone posted pictures on this forum some time ago about how he used Epoxy glue to hold the keyboard together. This I think needs some experimenting because most types of glue will not stick to thermoplastic material very well. In any case one must be very careful not to spill any glue inside the keyboard otherwise it will either cover the PCB contacts or block some keys.

Therefore taking apart the keyboard should really be the very last resort. One should always try to clean the contacts from the outside first.

Regards
Max